Related Manuals for Fn-Link FN-CC2541
Summary of Contents for Fn-Link FN-CC2541
- Page 1 FN-LINK TECHNOLOGY LIMITED Bluetooth Low Energy (BLE) Module FN-CC2541 User Manual / User Guide http://www.fn-link.com Page 1/8...
- Page 2 FN-LINK TECHNOLOGY LIMITED 1. Introduction FN-CC2541 is 2.4GHz Bluetooth low power system on chip (SoC), support 250kbps, 500kbps, 1Mbps and 2Mbps data rate, with connecting budget excellent, but the front end the application, receiving 1Mbps with a sensitivity of -94dBm, mainly used in the 2.4GHz Bluetooth low energy system, personal 2.4GHz system, man-machine interface such as a keyboard, mouse, and remote control etc., sports and leisure equipment,...
-
Page 3: Software Features
FN-LINK TECHNOLOGY LIMITED 1.2 SOFTWARE FEATURES Sample Applications and Profiles Generic Applications for GAP Central and Peripheral Roles Proximity, Accelerometer, Simple keys, and Battery GATT Services More Applications Supported in BLE Software Stack Multiple Configuration Options Single-chip configuration, allowing applications to run on CC2541... - Page 4 FN-LINK TECHNOLOGY LIMITED 2.2 Connector Pin Definition Pin # Name Description 2-3.6V 2-3.6V P2-2 P2-0 P2-1 USBDP-SCL USBDM-SDA USBVDD P1-6 http://www.fn-link.com Page 4/8...
- Page 5 FN-LINK TECHNOLOGY LIMITED P1-7 P1-5 P1-1 P1-0 P0-7 P0-6 P0-5 P0-4 P0-3 P0-2 P0-1 P0-0 RESET TX/RX RF TX/RX http://www.fn-link.com Page 5/8...
- Page 6 FN-LINK TECHNOLOGY LIMITED 2.3 Layout reference 3. Antenna Specification Antenna plate FPC antenna Antenna gain 0dBi Frequency range 2.4GHZ-2.483GHZ POWER 0dBm Connector type Fixed antenna company name HJ HECH http://www.fn-link.com Page 6/8...
- Page 7 FN-LINK TECHNOLOGY LIMITED 4. Antenna Installation Guide 4.1 Check FN-CC2541 Module connection pin is clean for soldering. 4.2 Place the Module on the Master PCB. Then solder it. 4.3 After soldering, Check all pads are well connected. http://www.fn-link.com Page 7/8...
- Page 8 FN-LINK TECHNOLOGY LIMITED 5. Package 5.1 blister packaging Vacuum packaging A piece of 50 PCS (500 pcs/bag) http://www.fn-link.com Page 8/8...
- Page 9 FCC Statement: The final end product must be labeled in a visible area with the following "Contains TX FCC ID:2AATL-FNCC2541". If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 stayement is required to be availale in the users manual: This device complies with part 15 of the FCC Rules.
Need help?
Do you have a question about the FN-CC2541 and is the answer not in the manual?
Questions and answers