Table of Contents
Advertisement
How to Set up Your Display Setting (Windows only)
The Windows display-settings for a typical computer are shown below. But the actual screens on your
PC will probably be different, depending upon your particular version of Windows and your particular
video card. But even if your actual screens look different, the same, basic set-up information will apply
in almost all cases. (If not, contact your computer manufacturer or Samsung Dealer.
Continued...
46
On the windows screen, select in the following
sequence : Start
Settings
Control Panel.
When the control panel screen appears, click on
"Display" and a display dialog-box will appear.
Select the "Settings" tab in the display dialog-box.
The two key variables that apply the PDP-PC inter-
face are "resolution" and "colors." The correct set-
tings for these two variables are:
• Size (sometimes called "resolution"):
1024 x 768 pixels.
• Color: "24-bit" color (might also be expressed
as "16 million colors")Shown at left is a typical
screen for "Display" dialog box.
If a vertical-frequency option exists on your dis-
play settings dialog box, the correct value is "60"
or "60 Hz." Otherwise, just click "OK" and exit
the dialog box.
Notes:
Both screen position and size will vary, depending on the type of PC monitor and its resolution.
The table below shows all of the display modes that are supported:
Vertical
Video signal
Dot X Line
Frequency (Hz)
640 X 350
70.086
85.080
640 X 400
85.080
720 X 400
70.087
85.039
640 X 480
59.940
72.809
IBM PC / AT
75.000
Compatibler
85.008
800 X 600
56.250
60.317
72.188
75.000
85.061
1024 X 768
60.004
70.069
75.029
84.997
1152 X 864
75.000
1280 X 1024
60.020
75.025
(N: Negative / P: Positive)
• The PDP might operate abnormally if a non-standard video format is selected.
• When this PDP is used as a PC display, 24-bit color is supported (over 16 million colors).
• Your PC display screen might appear different depending on the manufacturer (and your particular
version of Windows).
Check your PC instruction book for information about connecting your PC to a PDP.
• If a vertical and horizontal frequency-select mode exists, select 60Hz (vertical) and 31.5kHZ
(horizontal).
• In some cases, abnormal signals (such as stripes) might appear on the screen when the PC power is
turned off (or if the PC is disconnected). If so, press the Source button to enter the VIDEO mode.
Also, make sure that the PC is connected.
• Connect only a PC monitor to the monitor output port while viewing the PC screen.
(Otherwise, random signals might appear).
Horizontal
Vertical
Horizontal
Frequency (Hz)
polarity
polarity
31.469
N
P
37.861
N
P
37.861
P
N
31.469
P
N
37.927
P
N
31.469
N
N
37.861
N
N
37.500
N
N
43.269
N
N
35.156
N/P
N/P
37.879
P
P
48.077
P
P
46.875
P
P
53.674
P
P
48.363
N
N
56.476
N
N
60.023
P
P
68.677
P
P
67.500
P
P
63.981
P
P
79.976
P
P
47
Advertisement
Table of Contents
