Replacing Razor Head Assembly; Maintenance; Storage - Philips 8020X/33 Manual

ENGLISH
22

Replacing Razor Head Assembly

◗ Replace the entire Razor Head Assembly once
a year for optimal shaving results.
◗ Replace damaged or worn Razor Head
Assembly with model HS85 Philips Norelco
razor heads only.
C
1
Remove Razor Head Assembly from the
razor by pulling the Razor Head Assembly
straight up away from the razor.
C
2 Place new Razor Head Assembly back on
the razor and push down (you will hear a
click).
The Razor Head Assembly will only fit correctly
in one position on razor. Make sure to align the
2 shaving lotion dispensing holes on the Razor
Head Assembly with the 2 shaving lotion tubes on
the razor.
This razor has no other user-serviceable parts.
For assistance call 1-800-243-3050.

Maintenance

◗ Always remove razor from the charging stand
before cleaning appliance.
◗ Unplug the charging stand. The stand may be
wiped clean using a damp cloth.
◗ Water from the tap should be on a warm
setting to clean any washable parts.
Note: DO NOT place or clean any parts of the
charging stand in a dishwasher.

Storage

◗ The razor can be placed in the charging stand
for safe storage. If storing razor in charging
stand, remove the plug from outlet as soon as
the razor is fully charged.
◗ If appliance will not be used for an extended
period of time, it is recommended that you
thoroughly clean Razor Head Assembly
before storing.
◗ Be sure razor is turned off. Remove cord from
outlet and charging stand before storing in a
safe, dry location where it will not be crushed,
banged, or subject to damage.
◗ Do not wrap cord around razor or charging
stand when storing.
◗ Store cord in a safe location where it will not
be cut or damaged.
◗ Do not keep charging stand permanently
plugged into outlet.
◗ Do not place or store charging stand where it
can fall or be pulled into a tub or sink, water
or other liquid while plugged in.
C
◗ During storage, always put the Protective
Razor Head Cap on razor to protect heads.
ENGLISH
23