Table of Contents
Advertisement
3.2.3 IR board Control Unit
1. Unplug the connector from the SSB.
Caution: be careful, as these are very fragile connectors!
2. Remove fixation screws [1] 、[2] and connector in red box from the IR board control unit.
3. Remove the IR lens, IR board and key function
When defective, replace the whole unit.
1
3.2.5 Small Signal Board (SSB)
Caution: it is mandatory to remount all different screws at their original position during re-assembly. Failure to do so may result in damaging the SSB.
1. Release the clips from the LVDS connector that connect with the SSB[1].
Caution: be careful, as these are very fragile connectors!
2. Unplug all other connectors [2] .
3. Remove all the fixation screws from the SSB [3].
2
2
2
Advertisement
Table of Contents
