HP Aruba EdgeConnect Extra-Small Chassis Quick Start Manual page 2

Quick Start Guide
IMPORTANT - READ THIS FIRST:
the Silver Peak Cloud Portal BEFORE setting up an EdgeConnect appliance. After
Orchestrator is registered with your account name and key, you can proceed with
EdgeConnect
EdgeConnect installation.
If you don't know or are unsure of Orchestrator's role, contact your network architect
or deployment lead.
EdgeConnect Extra-Small Chassis
EdgeConnect Small Chassis
1
Approve the Discovered Appliance
EdgeConnect Medium Chassis
After you power on the EdgeConnect appliance, it automatically registers its serial number with
EdgeConnect Large Chassis
the Silver Peak Cloud Portal. The portal knows how to associate a serial number with a particular
EdgeConnect Extra-Large Chassis account.
a. Go to the Orchestrator.
Part 2 - Registration
b. In the header, click the blinking box named Appliances Discovered.
The Discovered Appliances page opens, listing the most recently discovered appliances fi rst.
Before You Begin
Make sure that Orchestrator is

installed and registered.
Verify that you've received the

email containing your Account
Name and Account Key.
c. After verifying that the appliance is yours, click Approve.
d. Select the group and click Apply.
The Appliance Manager Confi guration Wizard opens.
Aruba
6280 America Center Drive
San Jose, CA 95002
1.877.210.7325 (toll-free in USA)
+1.408.935.1850
www.silver-peak.com/support
You must install and register your Orchestrator with
2
Complete the Appliance Manager Confi guration Wizard
a. If you've also purchased EdgeConnect Boost or EdgeConnect Plus, and you want to apply it to
this appliance, select the relevant check box(es) on the Deployment Profi le page.
b. At the end, click Apply. It may take up to two minutes to register the appliance.
c. Complete the remaining wizard screens.
• On the Deployment page's default confi guration, the WAN–side interfaces use DHCP IP ad-
dresses, unless you manually enter static IP addresses.