Commissioning And Operation - M-E ODYON pro HS1 Instruction Manual

COMMISSIONING AND OPERATION

The hand-held transmitter is delivered ready for use with the battery inserted.
The hand-held transmitter is put into operation by teaching it to a suitable
ODYON pro receiver (see description of ODYON pro receiver). The function
triggered by this depends on the receiver and its wiring. A hand-held transmitter
can control several receivers with different wiring at the same time.
Reception control
If a button for channel 1-4 is pressed on the hand-held transmitter, the control
LED briefly lights up green. The receiver sends back a confirmation and the con-
trol LED flashes red/green briefly for confirmation.
If the control LED does not flash red/green, the corresponding button is either not
tuned in to a receiver or the hand-held transmitter is out of range of the receiver.
Automatic key lock
The hand-held transmitter is equipped with an automatic key lock to prevent
unintentional actuation of a function key (4), e.g. if the hand-held transmitter is in
EN
a pocket.
Activating the automatic key lock
Press and hold the standby button (3) for approx. 5 seconds until the control LED
(2) flashes green.
Deactivating the automatic key lock
Press and hold the standby button for approx. 5 seconds until the control LED
flashes red.
If the automatic key lock is activated, the hand-held transmitter must be brought
out of sleep mode by briefly pressing the standby key and then allows the taught-
in functions by pressing the key. If no further button is pressed within 5 seconds,
the hand-held transmitter returns to sleep mode.
When the key lock is deactivated, one of the function keys can be pressed directly
at any time and the radio signal is transmitted.
16