Related Manuals for MANN+HUMMEL 51 Series
Summary of Contents for MANN+HUMMEL 51 Series
- Page 1 Plate gap-type filter Series 51 and 55 Maintenance and repair instructions Order No. 1994 29 23 01 Version 1201 Printed in Germany...
-
Page 2: Table Of Contents
Technical Service Hotline instructions. MANN+HUMMEL GMBH is not liable for any Tel: +49 62 32 53 - 8265 technical errors or technical printing errors or Fax: +49 62 32 53 - 8370 omissions in these instructions. -
Page 3: Safety
In particular, with immediate effect. faults which impair the safety of this equip- ment must be rectified immediately. MANN+HUMMEL Industrial Filters... -
Page 4: Working Principles
The coarse dirt particles either sink to the lower conical part of the housing or form a filter cake on the filter body exterior. MANN+HUMMEL Industrial Filters... -
Page 5: Instruction To Find Malfunctions
Let out sludge, clean filter insert and housing, shorten sludge discharge inter- val. Filter body and /or gap cleaner worn out Take out gap filter insert, check for dam- age (see section 5.4) and if necessary replace completely. MANN+HUMMEL Industrial Filters... -
Page 6: Servicing/Corrective Maintenance
MANN+HUMMEL Industrial Filters... -
Page 7: Repair Procedure
= outlet screw packing collar or O-ring g = packing colar screw h = housing seal packing collar counternut k = seal locking screws hex. nut MANN+HUMMEL Industrial Filters... -
Page 8: Removing Filter Insert And Disassembly
6. Spare parts list see attached customer drawing 7. Tools required - Open ended spanner set, metric sizes 10 to 41 (accord. to filter size or type) - Container with petroleum ether for cleaning or diesel - Cleaning rags MANN+HUMMEL Industrial Filters...