Interlogix Advisor Installation Sheet

Table of Contents

Download this manual

Advisor Power Supply Installation Sheet

EN CNF ES PR

English: Installation Sheet

Description

The Advisor™ family of life-safety protection and comfort management systems detects situations, and provides control and

information for homes and businesses.

This document provides instructions on how to install or replace the power supply for the AdvisorOne panel and the Advisor

TouchScreen. The 12 VDC 2 A Power Supply (P/N AV-PS12V) can be used in North America and Europe (may require adapters in

Europe).

The Advisor power supply comes with two 8' cords (one cord is for the AdvisorOne panel and the other cord is for the Advisor

TouchScreen). The cord for the AdvisorOne panel contains bare wires that connect to the panel. The cord for the Advisor

TouchScreen contains a barrel connector that connects to the TouchScreen. A label on the TouchScreen cord denotes polarity.

There is also an optional 25' cord available with a barrel connector for the Advisor TouchScreen (P/N AV-TS-25CABLE).

Note: Unlike previous versions of power supplies, polarity matters. An improper connection could result in damage to the power

supply. Other Advisor panels may not be compatible with this power supply.

WARNING:

• Use caution when installing or removing the power supply to an outlet with a metal cover.

• Observe wiring gauge requirements for the power supply if not using the included wire.

• Make sure the correct polarity is observed when connecting the wires from the panel to the power supply.

P/N 466-4418 • REV A • 21MAY14

1 / 4

Table of Contents

Do you have a question about the Advisor and is the answer not in the manual?

Page 1 Europe). The Advisor power supply comes with two 8’ cords (one cord is for the AdvisorOne panel and the other cord is for the Advisor TouchScreen). The cord for the AdvisorOne panel contains bare wires that connect to the panel. The cord for the Advisor TouchScreen contains a barrel connector that connects to the TouchScreen.
Page 2 11. Connect the battery to the battery connector on the panel. Note that the cable connector locks into place. 12. Close the panel, making sure all tabs are engaged. Replace the screw securing the panel chassis. 13. If the central monitoring station was notified, inform them this operation is complete. 2 / 4 Advisor Power Supply Installation Sheet...
Page 3 Connect the new power supply barrel connector (I in Figure 2) to the back of the Advisor TouchScreen (J in Figure 2). Route the wire through the channel (K in Figure 2) in the back of the Advisor TouchScreen.
Page 4 Limitation of Liability To the maximum extent permitted by applicable law, in no event will Interlogix be liable for any lost profits or business opportunities, loss of use, business interruption, loss of data, or any other indirect, special, incidental, or consequential damages under any theory of liability, whether based in contract, tort, negligence, product liability, or otherwise.