Table of Contents
Advertisement
3. Follow to "Batt Low Check" mode......... (Slave TDD is displayed on LCD)
4. Set 2.37V for DC power supply.
Note: Check voltage at battery connector, because some voltage drop is happened, using long
or thin cable.
5. Press "#" key to write voltage value in EEPROM.
6. Turn power off. Then this value is available.
12.5. Base Unit Reference Drawing
When connecting the Simulator and Equipments for checking, please refer to below.
Note: (*1) is refered to No.2 of
12.6. Handset Reference Drawing
When connecting the Simulator and Equipments for checking, please refer to below.
Note: (*1) is refered to No.2 of
12.7. Frequency Table
Check Table for RF Unit
Check Table for RF Unit
40
()
()
Advertisement
Table of Contents
