Get Started; Prepare The Remote Control; Auto Install Radio Stations; Set Clock - Philips MCM166/05 User Manual

4 Get started

Caution
•
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for
the model and serial number of your Micro
Hi-Fi. The model number and serial number
are on the back of your Micro Hi-Fi. Write the
numbers here:
Model No. __________________________
Serial No. ___________________________

Prepare the remote control

Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
3
1
2
Note
•
Before pressing any function button on the remote
control, first select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the batteries.

Auto install radio stations

When you connect the Micro Hi-Fi to the
power supply for the first time, or no radio
station is stored in this Micro Hi-Fi, Plug and
Play is activated to store all available radio
stations automatically.
1
Connect the Micro Hi-Fi to the power
supply.
[AUTO INSTALL - PRESS PLAY] (auto
»
install - press the PLAY button) is
displayed.
2
Press on the main unit to start
installation.
[AUTO] (auto) is displayed.
»
The Micro Hi-Fi automatically store
»
radio stations with sufficient signal
strength.
When all the available radio stations
»
are stored, the first preset radio station
is broadcast automatically.

Set clock

1
Press and hold CLOCK/DISPLAY to
activate the clock setting mode.
The 12 hour or 24 hour format is
»
displayed.
2
Press PROG repeatedly to select 12 hour
or 24 hour format.
3
Press CLOCK/DISPLAY to confirm.
» The hour digits are displayed and begin
to blink.
4
Press / to set the hour.
5
Press CLOCK/DISPLAY to confirm.
The minute digits are displayed and
»
begin to blink.
6
Press / to set the minute.
7
Press CLOCK/DISPLAY to confirm.
EN
11