Bosch HGB320E50M User Manual And Installation Instructions page 25

Fault
Burner does not ig-
nite.
Burner goes out
straight after being ig-
nited.
The burner flame is
not uniform.
The burner flame
goes out while the
appliance is in opera-
tion.
The gas grill does not
work.
16.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note: Heat-resistant, 25-watt bulbs are available from
the after-sales service or specialist retailers. Only use
these bulbs.
WARNING ‒ Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
Caution should be exercised here in order to avoid
▶
touching heating elements.
Young children under 8 years of age must be kept
▶
away from the appliance.
WARNING ‒ Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
Before replacing the bulb, ensure that the appliance
▶
is switched off in order to prevent a potential electric
shock.
Also unplug the appliance from the mains or switch
▶
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ A new halogen bulb to replace the old one is avail-
able.
Cause and troubleshooting
The safety valve for the gas line is closed.
Open the safety valve for the gas line.
▶
Gas cylinder is empty.
Replace the gas cylinder.
▶
There is air in the gas line following initial connection or a cylinder change.
Turn the control knob to 0.
1.
Ignite the burner again.
2.
If necessary, repeat the ignition several times.
3.
The control knob was not held down for long enough.
Keep the control knob pressed in for a few seconds after ignition.
1.
Push the control knob in firmly.
2.
Openings on the burner are soiled.
Clean and dry the openings on the burner.
▶
The burner parts are positioned incorrectly.
Position the burner parts precisely and evenly.
1.
Ensure that the locking catches click into place in the recesses.
2.
Openings on the burner are soiled.
Clean and dry the openings on the burner.
▶
Gas cylinder is empty.
Replace the gas cylinder.
▶
The protective plate is incorrectly inserted.
Ensure that the protective plate has been inserted correctly.
1.
Remove the protective plate and reinsert it.
2.
Place a tea towel in the cooking compartment to
1.
prevent damage.
2. Turn the glass cover anti-clockwise to remove it.
Remove the oven light bulb.
3.
Replace the oven light bulb with the same type of
4.
bulb.
Screw in the glass cover.
5.
Remove the tea towel from the cooking compart-
6.
ment.
Connect the appliance to the power supply.
7.
16.3 Glass cover
If the glass cover is damaged, replace it immediately.
Suitable glass covers are available from the after-sales
service.
Specify the E number and FD number of your appli-
ance.
Troubleshooting en
25