Select Alarm Source - Philips AJ7030D/98 User Manual

1
Press and hold AL1/AL2 for two seconds to activate alarm
setting mode.
» The hour digits and alarm icon begin to blink.
2
Press TUNING +/- or
3
Press AL1/AL2 to confirm.
» The minute digits begin to blink.
4
Repeat steps 2 to 3 to set the minute and alarm volume. G

Select alarm source

Adjust AL1/2 iPhone·RADIO·BUZZ control to select alarm
source for both alarms.
Note
•
When alarm time comes, the selected radio, buzzer, or iPod/iPhone
turns on.
•
You can only select the same alarm source for Alarm 1/ Alarm2.
•
If iPhone is selected as alarm source, while no iPod/iPhone is
connected, the clock radio switches to buzzer source instead.
Activate/deactivate alarm timer
1
Press AL1/AL2 to view alarm settings.
2
Press AL1/AL2 again to activate or deactivate the alarm timer.
or
»
is off.
•
To stop the ringing alarm, press the corresponding
AL1/AL2.
•
The alarm repeats ringing for the next day.
/
appears if alarm timer is on and disappears if it
to set the hour.