Advertisement
DR5000 DIGICENTRAL
18.02.2019
Change LAN/WLAN se ngs
Index
Overview of how the DR5000 can work in a network.
What can I set under LAN everything?
What can I set under WLAN everything?
How can I set the network protocol (Z21, XpressNet, etc.)?
© Copyright 2005 – 2018 Digikeijs, the Netherlands. All
rights reserved. No informa-on, images or any part of
this document may be copied without the prior wri0en
permission of Digikeijs.
www.digikeijs.com
DR5000
Firmware from
V1.5.1
(2019-02-18)
quick guide
Page
2
3
4
5
P 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Digikeijs DR5000
Summary of Contents for Digikeijs DR5000
- Page 1 Change LAN/WLAN se ngs Index Page Overview of how the DR5000 can work in a network. What can I set under LAN everything? What can I set under WLAN everything? How can I set the network protocol (Z21, XpressNet, etc.)? ©...
- Page 2 Overview of how the DR5000 can work in a network. The DR5000 central unit is equipped with a built-in network router as standard. This means that the central unit can be accessed via either a LAN or a WLAN network. This allows control programs, such as iTrain® or Windigipet® (and others with network support), to communicate with the control centre via the DR5000's own network without using the USB cable and only via the Lan interface.
- Page 3 You can adjust the LAN seIngs using the configura-on soKware. (Normally, the DR5000 recognizes the IP address automa-cally. This requires the DR5000 to be connected to the home network.) If the DR5000 does not recognize its IP address, it must be searched for in the network router and then entered in point 1) below. If you do not have sufficient knowledge of network technology, the default seIngs should not be changed.
- Page 4 Reset network seIng If the DR5000 is not connected via the Lan interface to the home network (router) or via Wlan to the PC or laptop, the Lan seIngs of the DR5000 are grayed out and not accessible and therefore cannot be changed! A connec-on via USB to the DR5000 is always required to change the Lan seIng! Please pay a0en-on! www.digikeijs.com...
- Page 5 The DR5000 can now communicate using the selected protocol. If the DR5000 is not connected via the Lan interface to the home network (router) or via Wlan to the PC or laptop, the Lan seIngs of the DR5000 are grayed...
Need help?
Do you have a question about the DR5000 and is the answer not in the manual?
Questions and answers