Heico Quell EESeal Instructions

Insertion Instructions
®
EESeal
for D-Subminiature Connectors
The design and construction of EESeal
and without special tools. However, care is needed to ensure proper insertion.
Step 1- Which side is UP?
If your EESeal has a blank side with no
®
printing on it, the blank side is up and visible
once the EESeal
®
If both sides of your EESeal
on them, then the side with the EESeal
logo is facing up and is visible after the
EESeal is inserted.
®
Important Note: It is imperative that the EESeal
so will prevent the EESeal
problems.

Step 2 - Orient the EESeal

The "D" shape of the EESeal
match up to the "D" shape of the connector.
With the correct side up, orient the EESeal
so its pinholes roughly correspond to
the corresponding pins in the host
connector.
Important Note: It is imperative that the EESeal
with the matching pins in the connector. The "D" shape of the EESeal
to the "D" shape of the connector. Your EESeal
pin, and proper orientation will ensure each pin gets the correct circuit connection.
Quell Corporation |
A HEICO
5639 Jefferson NE Albuquerque, NM 87109 USA
FilterSeals makes them easy to install by hand
®
is inserted.
have printing
®
®
®
from working as it is intended to and may cause functional
®
needs to
®
Company
®
One Sided Printing
Blank Top
"right side up"
Bottom
®
be inserted "right side up". Failure to do
®
®
be inserted so its pinholes are aligned
®
may have a different treatment for each
505.243.1423
EESeal@Quell.US
www.eeseal.com
Two-Sided Printing
Top with EESeal ® Logo
"right side up"
Bottom
® needs to match up