Heico Quell EESeal Quick Start Manual

® Manual insertion Instructions
EESeal
for MDM Connectors
Manual Insertion Instructions for MDM Style EESeal
Warning: The very high density of MDM Style EESeals
sockets make the installation more difficult than our standard EESeals
Insertion Tools over hand insertion. Please follow these instructions carefully and take your time. We
recommend using some magnification the first time or two.
Since this EESeal is so small, a rubber tool is suggested to assist with installation, and may have been
®
provided with your order (a pencil eraser from a mechanical pencil will also work).
Begin installation by orienting the EESeal
with the host connector's shell.
Important Note: It is imperative that the EESeal
visible after it is inserted). The MDM connector is symmetrical about the vertical centerline and, thus, if an EESeal
incorrectly inserted with the EESeal
Next, place the EESeal
aligned. Now, simply start inserting the EESeal
until it rests just over the MDM sockets. Do NOT try to seat it over the sockets with your fingers. First, verify
that the EESeal ® is closely aligned with the MDM shell and sockets.
You are now ready to insert the EESeal
starting at one end of the connector, to gently work the EESeal
sockets should barely poke through each corresponding hole in the EESeal
slivers of silicone trimmed from the EESeal's
Once it is confirmed that the tip of every MDM socket is just poking through its corresponding hole in the
EESeal ® , then the EESeal
the host connector.
For additional information or to see an instructional video, Visit:
https://eeseal.com/installation-MDM/
Extraction: MDM style EESeals
the inserted EESeal ® and slowly work it out. Slowly work it up the shaft of all sockets a little bit at a time, working around the
perimeter. Do not try to pry the EESeal
EESeal ® out will minimize tearing and make it easier to get it out in one piece without leaving torn sections behind.
Quell Corporation |
A HEICO
5639 Jefferson NE Albuquerque, NM 87109 USA
so the EESeal
®
® be inserted "right side up" (with the EESeal
® logo up, it will not filter the correct pins or will not function properly.
® onto the MDM connector so the MDM sockets and the EESeal
® onto the tips of the MDM sockets. Use the flat side of the rubber tool,
®
® can be fully seated by simply using the mating connector to push it to the bottom of
® cannot be extracted without damaging the EESeal
® completely off some sockets when other sockets are still fully seated. Slowly working the
Please call (505) 243-1423 or
Email EESeal@Quell.us for Assistance
Company
®
and potential cutting action of the MDM connector's
®
blank side face up and match the EESeal's
®
® into the connector shell by pushing down with your thumb
down over just the tips of the sockets – the
®
pinholes during this process, which is normal.
®
Questions?
FilterSeals
®
® . Quell recommends using the MDM
® logo down and no printing
® pinholes are roughly
® . You may notice some very minor
. Use any dull probe to carefully reach under
505.243.1423
EESeal@Quell.US
www.eeseal.com
shape
®
® is