Heico Quell EESeal Instructions

Insertion instructions for circular connectors

Advertisement

Insertion Instructions
®
EESeal
for Circular connectors
The design and construction of EESeal
and without special tools. However, care is needed to ensure proper insertion.

Step 1 - Which side is UP?

The side with the EESeal
and visible after the EESeal
Important Note: It is imperative that the
®
EESeal
be inserted "right side up". Failure to
do so will prevent the EESeal
as it is intended and may cause functional
problems.

Step 2 - Orient the EESeal

With the correct side up, orient the EESeal
so its p i n h o l es r o u g h l y align to the
corresponding pins in the host connector.
Most EESeal
®
have at least pin A (or pin 1 if
your connector has numbers) marked to
assist you in this orientation.
Important Note: It is imperative that the EESeal
matching pins in the connector – pin A to pin A, or pin 1 to pin 1, and so on. Your EESeal
different treatment for each pin, and proper orientation will ensure each pin gets the correct circuit
connection.
Quell Corporation |
A HEICO
5639 Jefferson NE Albuquerque, NM 87109 USA
FilterSeals makes them easy to install by hand
®
logo is facing up
®
®
is inserted.
®
from working
®
®
Company
®
Top
"right side up"
®
be inserted so its pinholes are aligned with the
505.243.1423
EESeal@Quell.US
www.eeseal.com
"A" Pinhole
EESeal Logo
"Bottom"
Pin A
Connector
Shell
®
may have a

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Quell EESeal and is the answer not in the manual?

Questions and answers

Summary of Contents for Heico Quell EESeal

  • Page 1 – pin A to pin A, or pin 1 to pin 1, and so on. Your EESeal may have a different treatment for each pin, and proper orientation will ensure each pin gets the correct circuit connection. Quell Corporation | A HEICO Company ® 5639 Jefferson NE Albuquerque, NM 87109 USA...
  • Page 2 EESeal ® Circular Insertion Step 3 PARTIALLY Insert the EESeal ® Lightly push the “A” Slightly cup the EESeal ® so that Pinhole A (or pin pinhole onto just the tip of pin A 1) can be easily slipped onto the corresponding pin in the host connector.

Table of Contents