Clean Cloth
C
To lock stand, slide to left
Step 2: Placing the unit
Before you start....
– Make sure that all cables have been
connected to this unit.
– To prevent this unit from being
scratched, always covers its front surface
with a cloth before you place it fl at on
any surface.
Option 1: Placing on the table top
A
Place this unit on a fl at surface with the
front panel facing down.
B
Place the detachable stand on the rear
panel.
C
Slide the stand to the left to lock it into
position.
1_dvp6620-88_93_eng1_final813.in15 15
1_dvp6620-88_93_eng1_final813.in15 15
Basic Connections
A
B
A
IR
Option 2: Mounting on the wall
CAUTION!
Risk of personal injury and damage
to the unit. Allow only qualifi ed
persons to mount the unit.
Note:
Mounting accessories not supplied.
A
Mark the wall for screw hole positions
where you intend to mount this unit,
then drill the screw holes.
B
Insert the rubber wall plugs and screws
into the holes.
C
Hook this unit fi rmly onto the screws
and lock into position.
Helpful Hint:
– To remove the stand, press and hold the
catch at the extreme right of the rear panel
and push the panel towards the right.
(continued)
B
C
15
2008-03-24 2:32:29 PM
2008-03-24 2:32:29 PM