Capetti Elettronica Wine Cap MWDG-ETH Configuration Manual

1. LAN Connection

To connect the MWDG-ETH to internet or to use it through the LAN, following operations must be performed:
a. Power up the MWDG-ETH basestation;
b. Connect the ethernet cable between the basestation and an available LAN port;
Connecting the LAN cable, the COM
LED lights up in green to declare the
successful connection
c. Obtaining an IP address, by default, is performed through a call to the DHCP server. If the host network
doen't have the DHCP service set to active, passed a timeout period the Ip is automatically assigned (
d. In case a manual setup is needed, for example to set a static IP address, install and use the "DeviceInstaller"
software to reach the basestation . Please refer to "DeviceInstaller" chapter.

2. Service Center Connection

In order to obtain Internet access and download data to the Service Center WineCap (www.winecap.it) external
server, the DHCP service or the manual setup of the network configuration must provide the insertion of the Gateway
IP and DNS server useful for the external connection.
CONNECTION TEST: to verify the connection to the Service Center a command "4" must be issued: CCS connection
Using the WineCapKey
a. Approach the WineCapKey to the sensitive point. the SYSTEM led enlights in ORANGE;
ORANGE flash every 3 seconds
Approach the WineCapKey
b. Wait for 4 ORANGE flashes keeping close the WineCapKey;
c. Remove the WineCapKey to confirm the 4 command. Il CCS led lights up in green to show the connection in
progress status.
CAPETTI ELETTRONICA s.r.l. - Strada Stratta 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail info@capetti.it - web www.capetti.it
MWDG-ETH
LAN Configuration Manual
);
AUTOIP
REV04
1/6