Radio; Mp3 Player - Philips HTS3551/12 User Manual

3
Press Navigation buttons and OK to select
the following settings:
•
[Slide Animation]: Select an animation
for the slideshow.
• [Duration per slide]: Select a display
speed for each picture in a slideshow.
4
Press to stop the slideshow.
Musical slideshows
Create a musical slideshow to play music and
pictures at the same time.
1
Select a music track, and then press OK.
2
BACK, and go to the picture
Press
folder.
3
Select a picture, and then press
start the slideshow.
4
Press to stop slideshow.
5
Press again to stop music.

Radio

Listen to FM radio on your home theater, and
store up to 40 radio stations.
What you need
•
FM antenna.
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are
prompted to install the radio stations again.
•
For the best reception, place the antenna away
from the TV or other sources of radiation.
Tune stations
1
Connect the FM antenna as described in the
Quick start guide.
2
Press RADIO.
» If you have already installed the radio
stations, the last channel that you listened
to is played.
» If you have not installed any radio
stations, the message AUTO INSTALL...
PRESS PLAY appears on the display
panel. Press
3
Press the following buttons to listen or to
change radio stations:
EN
20
(Play) to
(Play).
Button Action
Select a preset radio station.
/
Navigation Search for a radio station.
buttons (left/
right)
Navigation
Fine tune a radio frequency.
buttons (up/
down)
Press to stop the installation of
radio stations.
REPEAT
Manual: Press once to access
program mode, and press again
to store the radio station.
Automatic: Press and hold for
three seconds to reinstall the
radio stations.
RADIO
Toggle between the stereo and
mono sounds.
Listen to radio
1
Press RADIO.
•
To listen to a preset station, press
or .
•
To search for a radio station, and then
listen, press Navigation buttons (left/
right).
2
Press +/- (Volume) to change the volume.

MP3 player

Connect your MP3 player to play your audio files
or music.
What you need
•
An MP3 player.
•
A 3.5mm stereo audio cable.
Play music
1
Connect the MP3 player to the home
theater as described in the Quick start
guide.
2
Press AUDIO SOURCE repeatedly until
'MUSIC I-LINK' appears on the display
panel.
3
Press the buttons on the MP3 player to
select and play audio files or music.