Table of Contents
Advertisement
4.6. Connecting the Lithium battery to the load/charger
4.6.1. Connecting a single Lithium battery to the load/charger
with a bi-stable relay
Warning! Ensure you have completed all the previous steps described in
chapter 4.5 before connecting the battery to the load/charger.
1. Slide the terminal covers over the connection wires.
2. Connect the + terminal of the battery to the - or A terminal of the relay (Figure 10).
3. Connect the load or charger to the + or B terminal of the relay.
4. Connect the - terminal of the battery. Do not connect the - terminal first as this may
lead to short circuits (Figure 10).
5. Ensure both contacts are tightened to 13Nm.
6. Place the terminal covers over the terminals (Figure 11).
7. Press the reset button for 10-15 seconds after connecting the bi-stable relay to Con1
output. (the reset button is located under the fuse cover). The bi-stable relay con-
tacts will be turned off and on, this is to make sure that the bi-stable relay is ON
1
5
4
Figure 10. Connecting the battery to the load
WhisperPower Lithium Plus 12 V 210 Ah 340 Ah
3
20 Nm
2
Bi-stable Relay
21
Advertisement
Table of Contents
