Signal Connections; Control Personalities; Dmx Linking; Remote Device Management (Rdm) - Iluminarc LOGIC Drive 2X User Manual

Signal Connections

The LΩGIC Drive 2X can receive a DMX, RDM, Art-Net™, or sACN control signal. If using other
compatible products with this product, each can be individually controlled with a single controller.

Control Personalities

The LΩGIC Drive 2X uses a 5-pin phoenix connection to receive DMX or RDM, or an ethernet connection
to receive Art-Net™ or sACN, and a CAT6 ethernet connection to send control data to connected products
for its 9 control personalities, ranging from 1 to 10 channels.
• Refer to the Operation
personalities.
• The Control Channel Assignments and Values
control personalities.
If you are not familiar with or need more information about DMX standards or the DMX
cables needed to link this product to a DMX controller, download the DMX Primer from the
Chauvet website: www.iluminarc.com.

DMX Linking

The LΩGIC Drive 2X will work with a DMX controller using a 5-pin phoenix connector. For more
information about DMX, read the DMX primer at:
uploads/2016/06/DMX_Primer.pdf.
DMX Output

Remote Device Management (RDM)

Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate
bi-directionally along existing DMX cabling. Check the DMX controller's User Manual or with the
manufacturer as not all DMX controllers have this capability. The LΩGIC Drive 2X supports RDM protocol
that allows feedback to make changes to menu map options.

DMX/RDM Connection Diagram

DMX or RDM Controller
To other DMX or RDM devices
7
chapter to learn how to configure the LΩGIC Drive 2X to work in these
https://www.chauvetprofessional.com/wp-content/
1. Ground
2. Data 1 -
3. Data 1 +
4. Not used
5. Not used
section provides detailed information regarding the
Signal Connector
LΩGIC Drive 2X
LΩGIC Drive 2X User Manual Rev. 1
Setup
To LΩGIC products