A 6500 Wall Plate - Redback A 6500 Operating Manual

Redback® Programmable Control System
2.0 CONNECTION GUIDE
2.1 A 6500 WALL PLATE CONNECTION GUIDE
Fig 2.1a shows the layout of the front of the A 6500 wall plate with the cover removed.
A 6500
Fig 2.1b shows the layout of the rear of the A 6500 wall plate.
1) RJ45 Connector
2) Micro USB Connector
3) Micro SD Card
4) IR Sensor
4 Redback® Proudly Made In Australia
! CAUTION !
DO NOT
OVERTIGHTEN AS
DAMAGE MAY RESULT
1) Mini USB Connector
2) Micro SD Card
3) IR Sensor
IR SENSOR
Fig 2.1a
Fig 2.1b
The location of the IR sensor, Micro SD card and
USB connector are shown.
1 Micro USB Connector
This connector is for the connection of a USB
keyboard for learning IR codes.
2 Micro SD Card
The SD card is use to store all the icon and
button configuration information.
(Note: The Micro SD Card is inserted with the
contacts facing the front of the wall plate).
3 IR Sensor
This sensor is used to learn IR codes.
The location of the RJ45 Connector, IR
sensor, Micro SD card and USB connector are
shown.
1 RJ45 Connector
This is used for the connection
between the wallplate and Serial Hub
or Distribution boxes. Connection is
made using Cat5/6 cable to a
maximum distance of 50m.
2 Micro USB Connector
This connector is for the connection
of a USB keyboard for learning IR
codes.
3 Micro SD Card
The SD card is use to store all the icon
and button configuration information.
(Note: The Micro SD Card is inserted
with the contacts facing the front of
the wall plate).
4 IR Sensor
This sensor is used to learn IR codes.
Connection Guide