Data Industrial 330 Owner's Manual page 5

Programming
Programming the Model 330 is accomplished by installing the Data Industrial programming software on
a computer and entering data on templates of the Windows
1. Load the interface software into the computer.
2. Connect the computer to the Model 330 transmitter with the Data Industrial A-301 communications
cable to the socket labeled “D.I.C Comm Port”, taking care to properly align the tab on the plug and
socket to maintain polarity. Connect the DB9 connector of the Data Industrial A301 communications
cable to a PC com port that has the Model 330 software installed.
3. Connect the Model 330 transmitter to a power supply.
4. Open the interface software and select the appropriate COM PORT as shown in the dialog box
below.
5. Open the Parameters Screen as shown below.
To go to the calibration
settings screen press
"Parameters" from either
place shown.
Data Industrial
based program.
®
Model 330 Owner's Manual
5