Tavistock CM450F Installation & Aftercare Instructions

CM450F
COMPASS CLOAKROOM FLOOR MOUNTED UNIT
INSTALLATION & AFTERCARE INSTRUCTIONS

Before You Start

It is recommended that the unit and basin are secured to a suitably reinforced wall to ensure stability. This can be done through the back rail.
(Fixings not included).

Hinge Adjustment

The unit doors can be adjusted or removed if necessary. There are two adjustment screws on the hinges which make the adjustments shown
in the image below. The quick release bu�on on the back of the hinge can be used to remove the door completely.

Fitting Handles

• A pilot hole located at the back of the door can be drilled if using a single screw knob.
• If you have chosen a pull handle with 2 screws then please pilot and then drill through the door with the handles in the desired loca�on.
• Carefully drill any holes using a clamped block of wood to protect the front of door.
• The handles can simply be screwed into place using the screws supplied.
• If you choose third party handles please measure carefully before drilling.
1
Quick release
mechanism
2
3
t. 01225 787 870 e. info@tavistock-bathrooms.co.uk w: www.tavistock-bathrooms.co.uk
Note: Same soft close hinges used for
Compass Cloakroom Units
Tavistock, Brassmill Lane Trading Estate, Bath, BA1 3JF