What to do if...
Trouble Shooting
If the appliance is not working correctly, please carry out the following
checks before contacting your local AEG Service Force Centre.
Important: If you call out an engineer to a fault listed below, or to
repair a fault caused by incorrect use or installation, a charge will be
made even if the appliance is in guarantee.
• If the fault code E10, E20 or E40 is shown in
the multi-display, you may be able to remedy
the fault yourself (see the Faults table below) .
After clearing the fault, press the START/ PAUSE button. If the fault
code is displayed again, contact your local AEG Service Force Centre.
• For all other faults displayed in the multi-display, please contact your
local AEG Service Force Centre, stating the fault code.
Problem
The washing machine
does not work.
Door cannot be closed. The child safety feature is set
The fault code
appears. The display
MAIN WASH flashes.
No water flows.
E10
Fault code
appears. The display
RINSE + flashes
Possible Cause
The mains plug is not
plugged in.
The house fuse has blown.
The door is not correctly
closed.
START/PAUSE button not
pressed long enough.
E40
The door is not correctly
closed.
Water tap is closed.
Filter in screw connection of
the inlet hose is blocked.
Operating Instructions
Remedy
Plug in the mains plug.
Replace the fuse.
Close the door; The lock must
engage audibly.
Keep the START/PAUSE but-
ton pressed until the pro-
gram begins.
Cancel the child safety fea-
ture (see Section "Child
Safety Feature").
Close the door correctly.
Start the program again.
Open the water tap.
Close the water tap. Unscrew
the hose from the tap,
remove the filter and clean
under running water
29