Power Supply, Grounding And Shielding - gefran G-Vision 67-070 Operating Instructions Manual

6. POWER SUPPL Y , GROUNDING AND SHIELDING
The power supply terminal block is shown in the figure below.
Use a shielded CAT 5 cable or higher
Note: Ensure that the power supply has enough power
capacity for the operation of the equipment.
The unit must always be grounded to earth with shielded
CAT 5 cable. Grounding helps limit the effects of noise due to
electromagnetic interference on the control system.
81086_G-Vision 67_12-2021_ENG
Fig. 6.1
The earth connection can also be made using the screws
located near the connector. A label helps identify the ground
connection.
All the electronic devices in the control system must be
properly grounded. Grounding must be performed according
to applicable regulations.
15