Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Skynetic EPP-YAK54-1100
Summary of Contents for Skynetic EPP-YAK54-1100
- Page 2 NOTE: The photographs are older showing different branding but the parts and steps are the same. Parts included in the packing 1 Fuselage 2 Wing (right and left) 1.Set the servo mount on the servo. 3 Rudder(vertical tail) 1 pc 4 Elevator (stabilizer) 1 Landing gear system 2 Stab.
- Page 3 NOTE: The photographs are older showing different branding but the parts and steps are the same. 5.Use the hobby knife to cut a 10mm depth slot, make sure the servo wire to reach the receiver location . _____ _ .., 6.As the picture shown , insert the servo wire into the pre...
- Page 4 NOTE: The photographs are older showing different branding but the parts and steps are the same. 10. Fix the servo extension arm onto the servo arm with screw 11.lnstall the push rod connector onto the extension arm . 8.lnstall the left aileron servo. 12.Fix the servo arm by using the servo package which included.
- Page 5 NOTE: The photographs are older showing different branding but the parts and steps are the same. 17 .Use the screwer to tighten the push rod connector with 13.Pls use a hobby knife to cut a slot which is vertical to the screws .
- Page 6 NOTE: The photographs are older showing different branding but the parts and steps are the same. 21.Connect the left and right wing with 4 x 100 mm carbon rod, insert it into the wing slot. 22.Thread the servo wire through the hole till the receiver location.
- Page 7 NOTE: The photographs are older showing different branding but the parts and steps are the same. 31.Fix the servo extension arm onto the servo arm with screw 27 .Glue the control horn using CA. 32. Install the push rod connector onto the extension arm . 28.Glue the vertical stabilizer onto the fuselage.
- Page 8 NOTE: The photographs are older showing different branding but the parts and steps are the same. 40.lnstall the lipo battery pack ,and then fix them with velcro. 36. Insert the landing gear into the slot . 41.There is a receiver location under the wing, connect the 37.lnstall the motor into the motor mount ,and then tighten servo and ESC wire to the receiver , And then insert the them by using 4pcs screws.
Need help?
Do you have a question about the EPP-YAK54-1100 and is the answer not in the manual?
Questions and answers