Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Skynetic Trainer King
Summary of Contents for Skynetic Trainer King
- Page 1 USER MANUAL...
-
Page 2: Product Specifications
Introduction The Skynetic Trainer King EPP is a high wing trainer that is perfect for learning how to fly. Both wing and gear are easily removable for transport and/or flying preference. Made of light yet durable EPP foam with a high and ample-cambered wing and rugged tri-gear, the Trainer King is tailor-made for anyone wanting a capable trainer for flight training. -
Page 3: Parts Included In The Box
Parts included in the box ..,.__ _ _ _ _ 1. Elevator push rod 1.2*585MM 1 pc 10. Glass fiber servo horn 4pcs 2. Rudder push rod 1.2*545MM 1 pc 11. Push rod adjuster 4pcs 3. Front landing gear push rod 1 *285MM 1 pc 12. - Page 4 The items below are required for assembly...
- Page 5 The assembly steps: 4.Stick the carbon strips on middle leading edge and training edge with glue for reinforcement. 1.lnsert the 2pcs wing connecting plywoods into the slots on left wing. Fuselage 2. Align the right wing and insert the plywood into the slots on right wing. Make sure each half of plywood inside Landing gear the half wing is equal.
- Page 6 1 *285MM front landing gear push rod Front landing gear 6.lnsert the push rod (the end without Z bend) into the hole according to the position shown in the picture. 9.lnsert the landing gear into corresponding place in above picture, then fix it with screw. Servo arm for front landing gear ?.Connect the servo arm to Z bend.
- Page 7 12.Press the round plastic part into the propeller hub. Rudder 13. Install the propeller onto the motor shaft. 11. Please check there's a small pre-cut slot on rudder, please align this slot with the leading edge of stabilizer, then install the rudder on stabilizer with glue.
- Page 8 Elevator push rod 1.2*585MM Rudder push rod 1.2*585MM Fiberglass servo horn and adjuster Fiberglass servo horn and adjuster ---------------, Servo arm 15. Cut a small slot for installing the control horn (position refer to above picture), then insert the control horn and fix with glue. 14.
- Page 9 Install the servo arm for front landing gear and rudder. 20.Plug the pushrod into adjuster and keep the control surface in flat, then fix the adjuster with screwdriver. 17 .Connect the Z bend to servo arm and plug the pushrod into adjuster. 18.Fix the servo arm with screw.
- Page 10 22.Connect aileron pushrod to servo arm, then fix servo arm with screw. Fiberglass control horn and adjuster 23.Plug another end of push rod into adjuster, then fix it with screwdriver. ' _ ; ; . - - - 21.Cut a small slot on aileron for installing the control horn (position refer to above picture), then insert the control horn and fix with glue.
- Page 11 Rubber band One 11.1 V 3S 1300MAH LiPo battery is required 25.Fix the wing onto the fuselage by using rubber band. ··•: ! Receiver 26.Plug all servos connectors into your provided radio receiver. A minimum 4-channel receiver is required. -10-...
- Page 12 View the Pre-Flight Checklist on MotionRC.com before flying your Skynetic Trainer King for the first time. Following this guide will maximize your positive experience when flying this model airplane.
Need help?
Do you have a question about the Trainer King and is the answer not in the manual?
Questions and answers