Download Print this page

MATALA Biosteps10 Operation Manuallines

Pond filter

Advertisement

Quick Links

Advertisement

loading

Summary of Contents for MATALA Biosteps10

  • Page 2 O p e r a t i o n G u i d e l i n e s f o r BioSteps Pond Filter Dear Customer Congratulations on your selection of BioSteps10 as your pond filter! In the following instructions and guidelines we provide you with important information for installation, start-up and maintenance of your BioSteps10.
  • Page 3 Plug and play recommendations: complete filter systems for different pond sizes OPTIONAL Pond volume KOI CARP Number of Pump capacity Recommend UVC capacity Recommend Recommend Recommend (MAXIMUM RECOMMENDED FLOW RATE) Up to: Pond volume BioSteps hose diameter range Number of Number of Number of for pump to filter...
  • Page 4 Option 3) Biosteps10 with Waterfall Spillway option. ▪Check alignment of spillway with upper outlet hole in section 6 of body. ▪The top of spillway should fit flush against the body. ▪Install one O-ring over threads of outlet fitting. ▪Insert outlet fitting through inside of spillway.
  • Page 5 ▪You may need to twist clear hose socket until completely tight and flush with UVC. ▪Insert Green Matala section 2, Blue Matala Sec. 3, Gray Matala Sec. 4 & Sec.5. Slide partition screen after Gray Matala. ▪Insert partitioning screen after the Gray Matala in section 5.
  • Page 6 Water polishing: Section 6 (OPTIONAL) Substrate helps for This is a good area to place a water conditioning: bag of filter CARBON or Buffering of pH and ZEOLITE or Matala BIO-ACTIVE mineral content of STONE to help regulate pH. water.
  • Page 7: Filter Maintenance

    Lower the water level of the filter by opening the drain valve and simultaneously rinse the filter mats. Normally, this can be done without removing the Matala from the filter. Only in cases of heavy silting or clogging of the filter mats or substrate it will be necessary to remove these from the filter, clean and put back into position.
  • Page 8 The warranty doesn’t cover any problems resulting from inappropriate installation or operation, overloading, frost, use of force, third-party faults, mechanical damage or vandalism, or any defects caused by improper functioning or installation of pump, hoses or piping. DISTRIBUTED BY MATALA WATER TECHNOLOGY CO., LTD. www.matala.com.tw...