Download Print this page

MATALA EZClear EUV-16W Manual

Uv clarifier

Advertisement

Quick Links

Before using EzClear UV Clarifier, please make sure that the quartz sleeve is not broken and all connectors / fittings are tightened.
Once leaking is found, please stop using it in case of any accident.
Disconnect the power supply before any installation or maintenance, and do not pull the UV lamp up with the cable.
NOTICE
When using the EzClear UV Clarifier, always connect the power supply with ground fault circuit interrupter (GFCI).
CAUTION
Please turn off the power
before any maintenance
and keep away from the
UV-C
UV light when operation.
EPA Est. No.98547-TWN-1

Advertisement

loading
Need help?

Need help?

Do you have a question about the EZClear EUV-16W and is the answer not in the manual?

Questions and answers

joseph
June 9, 2025

does water flow into unit where plug is or at the other end?

Subscribe to Our Youtube Channel

Summary of Contents for MATALA EZClear EUV-16W

  • Page 1 CAUTION Please turn off the power before any maintenance and keep away from the UV-C UV light when operation. EPA Est. No.98547-TWN-1 Before using EzClear UV Clarifier, please make sure that the quartz sleeve is not broken and all connectors / fittings are tightened. Once leaking is found, please stop using it in case of any accident.
  • Page 2 1. Please check the box of version contains the items listed here: EUV-16W EUV-25W Only for EUV-25/40/75W EUV-40W/75W The water inlet / outlet at 90 degrees on EUV-16W, but EUV-25W/40W/75W on the same side. -Before using EzClear UV Clarifier, please make sure that the quartz sleeve is not broken and all connectors / fittings are tightened, especially: Quartz Sleeve Red Locking Ring...
  • Page 3 2. Please check the box of EUV2 version contains the items listed here: EUV2-16W EUV2-25W EUV2-40W/75W EUV2-145W -Before using EzClear UV Clarifier, please make sure that the quartz sleeve is not broken and all connectors / fittings are tightened, especially: Quartz Sleeve Red Locking Ring Blue Cap...
  • Page 4: Installation

    ATTENTION READ THIS MANUAL CAREFULLY BEFORE INSTALL AND KEEP IT FOR LATER REFERENCE. Caution – might void warranty !!! - ECzClear UV Clarifier is not submersible. Protect the unit and ballast from exposure to sun/heavy rain/snow. - Do not cut/manipulate/alter power cable or plug and use extension cable. CAUTION - Make sure proper 120 voltage is present under load.
  • Page 5: Dimensions And Specifications

    DIMENSIONS AND SPECIFICATIONS 15.5" / 393mm 25.8" / 656mm 37.5" / 953mm 8" / 203mm 18.3" / 466mm 30" / 763mm EUV-16W EUV-25W EUV-40W / 75W Model EUV-16W EUV-25W EUV-40W EUV-75W Spec. Voltage 110-120V / 60Hz , 220-240V / 50Hz 100-240V, 50 / 60Hz 4-section hose barb or half union 3/4"...
  • Page 6 original quartz sleeve from the blue cap. Remove the INTEGRATION OF THE UV-C UNIT original gasket and keep it. Tips: Before remove the gasket , please make note When integrating the EzClear UV Clarifier into the pond’s of the gasket’s position on the new quartz sleeve water recirculation and filtration system big particles or dirt as it was on the original quartz sleeve.
  • Page 7: Warranty

    Ballast: One year from the date of purchase. Contact the nearest authorized EzClear UV Clarifier dealer for warranty service. Matala EzClear UV Clarifier shall possess the sole right to determine whether to repair or replace defective equipment, parts or components.
  • Page 8 Fitting Bag for Replacement Fitting Bag for Replacement BSAB201004 BSAB201004 BSAB201004 : For EUV-16W~EUV-75W BSAB201004 : For EUV-16W~EUV-75W Parts No Parts No Parts / Spec Parts / Spec BS201020 BS201020 Plastic Nut 1-1/2" Plastic Nut 1-1/2" BS201021 BS201021 4-Section Hose Barb 3/4",1,1-1/4",1-1/2" 4 Section Hose Barb 3/4",1,1-1/4",1-1/2"...

This manual is also suitable for:

Ezclear euv-25wEzclear euv-40wEzclear euv-75wEzclear euv2-16wEzclear euv2-25wEzclear euv2-40w ... Show all