Advertisement
6
Washer
7
Bolt M12×25
Safety instructions
To avoid malfunctions, damage, and health impairments,
•
Unqualified persons must not use the engine hoist support beam.
•
Use the beam for its intended purpose, only for lifting vehicle engines. Never use the beam to
transport loads!
•
Make sure that the vehicle structure is suitable for the use of the beam. The surface of the
vehicle structure must be flat to prevent the beam from slipping.
•
Determine the most stable area of the vehicle structure to set up the beam. Do not place the
supports (11) with the rubber protective caps (12) on the mudguards (paint damage!), but on the
inside of the spray wall (upper mudguard attachment) or on the shock absorber receptacle.
•
Make sure that the vehicle cannot roll away when using the beam.
•
Do not use the beam if there is a risk of petrol or other dangerous substances leaking.
•
After the beam has been properly assembled, first tighten the bolts (7) and locking knurled
screws (2) to stabilise the bridge.
•
Never work under a raised engine!
•
Do not exceed the permissible load capacity of the beam.
•
Fasten the engine to be lifted by wrapping the load chains (14) around it and hang the chains
on the load hook. To lift the motor, tum the hand lever nuts (5).
•
Clean and lubricate the threads on all parts from time to time.
•
Store the beam in a dry place protected from moisture.
•
Modifications and alterations to the beam are not permitted. We accept no liability for damage
caused by improper use of the beam.
•
Do not use the beam with parts being bent or damaged.
Technical specifications
Load capacity (㎏)
Chain length (㎝)
Lifting height (㎝)
Weight (without chains) (㎏) 17
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction
manual require the written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
13 Load hook M20×2.5 (330 mm)
14 Load chain
observe the following instructions!
500
approx. 90
approx. 20
Item 30154
Page 4
01
2022-1
Advertisement
