Makita PV001G Instruction Manual page 11

Screw the side grip tightly into the mounting hole on
either side of the tool head.
Fig.12
► 1. Mounting hole 2. Side grip
Installing and removing wool pad
Optional accessory
CAUTION:
Make sure that the backing pad is
secured properly. Loose attachment will run out of
balance and cause an excessive vibration which may
cause loss of control.
CAUTION:
Make sure that the wool pad and
backing pad are aligned and securely attached.
Otherwise the wool pad will cause an excessive vibra-
tion which may cause loss of control or the wool pad
may be thrown out from the tool.
CAUTION:
Only use the hook-and-loop sys-
tem wool pads for polishing.
NOTICE:
Never actuate the shaft lock when the
spindle is moving. The tool may be damaged.
NOTICE:
Regularly clean accessories and spin-
dle to remove dust and debris. Wipe the compo-
nents clean with a cloth dampened in soapy water if
necessary.
1
2
3
4
Fig.13
► 1. Wool pad 2. Sleeve 18 3. Backing pad 4. Spindle
1
2
Installing wool pad
1. Press in the shaft lock to prevent spindle rotation,
and thread the backing pad into the spindle.
2. Hand tighten the backing pad securely.
3
1
Fig.14
► 1. Shaft lock 2. Backing pad 3. Spindle
3.
Insert the sleeve 18 into the center hole of the
backing pad.
4. Install the wool pad over the backing pad, passing
the sleeve 18 through the center hole of the wool pad.
Use the sleeve 18 as a positioning guide to align the
wool pad accurately along the backing pad.
5.
Pull the sleeve 18 out of the center hole of the
backing pad.
1
Fig.15
► 1. Sleeve 18 2. Backing pad 3. Wool pad
Removing wool pad
1. Gently peel the wool pad off the backing pad.
2.
Unscrew the backing pad while pressing in the
shaft lock.
11 ENGLISH
2
2
3