Panasonic SA-PM11 Service Manual page 31

2. Insert the Normal blank tape (QZZCRA) into DECK 2 and set the
unit to "REC" mode (
3. Adjust L1301 so that the output frequency is within the standard
value.
Standard Value: 97
±8 kHz
11.2. Tuner Section
11.2.1. AM-IF Alignment
- AM-IF ALIGNMENT
SIGNAL GENERATOR OR
SWEEP GENERATOR
CONNECTIONS FREQUENCY
Fashion a loop 450 kHz 30%
of several Mod. at 400Hz.
turns of wire
and radiate
signal into
loop of
receiver.
- AM-RF ALIGNMENT
use "REC/PAUSE" key).
RADIO DIAL
SETTING
OSCILLOSCOPE)
Point of non- Headphone Jack
interference (on/ (32
about 600 kHz) the plug as shown
in Fig. 2 and then
connect the lead
wires of the plug
to the measuring
instrument.
31
INDICATOR
ADJUSTMENT(Shown
(ELECTRONIC
VOLTMETER
Z102 (AM IFT)
) Fabricate
REMARKS
in Fig.3)
Adjust
maximum
output.