Accessory Installation - Geneinno GTP exCAM-1 User Manual

Accessory Installation

①
① Unscrew the sealing metal cover of the 8-pin waterproof connector of the
robot counterclockwise. Match the slot to the slide rail in the bottom of the
host, slide the external camara according to direction indicated by the
arrow .
② Align the screw with the hole and install the screws.
③ Insert the connector into the extension port on the robot host. Tighten it
clockwise.
Note: The connector has an anti-reversal insertion design, please pay
attention when inserting, please do not rotate when inserting, to avoid
damage to the pin and its internal structure.
Accessory Buoyancy Block Installation
① Align the mounting hole with the hole on bracket, with the arrow of
buoyancy block upward.
② Install the wing screw through the hole, insert from the outside to the
inside, and tighten the nut by hand.
Note: Four buoyancy blocks needed for the external camera. Please
install symmetrically. Excessive or uneven installation may affect the
underwater operation of the underwater robot.
© 2020-2022 GENEINNO All Rights Reserved
② ③
2