Setting the PC Audio
This function allows you to output or mute the sound
from your PC when connecting using the PC IN
terminal and an analog RGB cable. ( page 18)
To set the PC Audio:
1無
Press
and open the Sound menu.
2無
Highlight Audio Setup and press
3無
Press p or q to select PC Audio and then press
t or u to select No or Yes.
Yes: When viewing the PC input, the audio from
the PC Audio input can be heard.
No: When viewing the PC input, there will be no
audio.
Note: Because the PC and HDMI-1 inputs
share the same set of analog audio inputs,
the PC Audio menu setting influences the
HDMI 1 Audio menu setting. If PC Audio
is set to "No" the HDMI 1 Audio setting
changes to "Auto" If PC Audio is set to "Yes"
the HDMI 1 Audio setting is set to "Digital"
and is grayed out in the menu. (Also see
item 3 on page 12 and "Setting the HDMI
Audio mode" on page 26.)
Using the Media Player
Using the Media Player with USB
You can enjoy photos or music contents stored on a
USB storage device.
Photo Viewer specifications:
Data type: JPEG Exif ver2.1
File format: JPEG
Maximum photo size: 6 MB
Maximum number of files: 500 / folder
Maximum photo resolution:
1366 x 768 pixels (C110U)
1920 x 1080 pixels (E210U, G310U)
Music Player specifications:
File format: MP3
Sampling frequency: 16 kHz, 22.05 kHz, 24 kHz,
32 kHz, 44.1 kHz, 48 kHz
Bit rate: from 8 to 320 kbps
Maximum number of files: 500 / folder
Supported file system:
FAT16 and FAT32
Chapter 6: Using the TV's features
.
®
Note:
• Gently insert the USB device into the port and
do not remove while using the Media Player.
• USB device: USB Mass Storage Class device
(MSC)
• Support is not guaranteed for all devices.
• Connect the USB device directly to the TV.
• Do not use a USB Hub.
• You must obtain any required permission from
copyright owners to use copyrighted content.
Toshiba cannot and does not grant such
permission.
• Depending on the file size and amount in your
USB storage device, it may take some time to
load before content is viewable. A message
will display on-screen when loading files from
the USB storage device.
• Only limited types of U3 USB devices are
supported. Therefore, it is suggested you
do not to use U3 USB for the Media Player
function.
• Non-supported characters in the filename will
be replaced with a square( ).
To select the Auto Start function
1無
Press
and t or u to select the Setup menu.
2無
Press q to select Media Player, and then press
3無
Press p or q to select Auto Start.
4無
Press t or u to select On or Off.
To open the Media Player
There are two methods for starting the Media Player.
Automatically:
1無
Gently insert a supported USB storage device to
the USB port on the rear side of the TV. A prompt
will appear.
Note: If you repeatedly insert and remove
the USB device, the prompt may not appear.
2無
Press t or u to select Yes, and then press
the Media Player menu will appear. When you
select No, nothing happens.
Note:
• The prompt will disappear after about 10 sec.
• If Auto Start is set to Off, you can start the Media
Player manually.
.
,
(continued)
43