Cleaning And Maintenance - HJM VM23 Instructions Manual

Ventilador Mesa VM23-30-40_Maquetación 1 10/11/17 10:03 Página 19
2. Unscrew the nut of the grid fixing rear (11) from the the drive shaft
(5) by turning counterclockwise.
3. Insert the rear grille (12) on the motor shaft (5) making sure that
the handle on the back is facing upwards and the locking pins (A-
B) are in the vertical holes of the rear grille. Screw the locking ring
(11) by turning it clockwise.
4. Insert the fan (10) on the motor shaft (5) and fasten the proper lock
ring (9) by rotating counterclockwise.
5. Loosen the screw (7) from lock ring (14) and place it on the rear
grille (12).
6. Place the front grille (8) on the rear grille (12) making sure that the
logo on the central stud is placed horizontally, parallel with the
floor and making sure that it is well fixed to the lock ring (14).
7. Find the proper position tighten the safety screw (7) of the lock ring
(14).
WIND SPEED CONTROL:
0: Power OFF
1: Low speed
2: Middle speed
3: High speed (for model Ø30 cm and Ø40 cm only)
OSCILLATION CONTROL:
1. Push the oscillation knob located on the motor housing to oscillate
2. Pull the oscillation knob to stop the oscillation.

CLEANING AND MAINTENANCE

Operate in a dry area, free of excessive humidity and water.
Press "0" push button control to switch OFF the power and unplug
the fan before cleaning.
Only use a soft, damp cloth to clean the fan.
Do not use gasoline, paint thinners or other chemicals to clean the
fan.
Clean the fan thoroughly before storing in the original box or cover
the appliance with a plastic bag to protect it from dust.
- 19 -
E
N
G
L
I
S
H