Table of Contents
Advertisement
•
Pulse Width Trigger SYNC-NON RESET Picture Output Timing
(At Time of One-shot or Continuous External VD/Continuous External HD Input)
1
Trigger*
About 1 s
Exposure period*
1
External HD IN*
1
External VD IN*
(Internal VD)
VIDEO INDEX
Video output
*1: Externally input signal
*2: Exposure time = Trigger pulse width + 6 s
(Valid trigger pulse width is 2 s or greater for external trigger shutter operation.)
*3: Video is output at the falling edge of the internal VD following completion of the exposure
period.
The video and the VIDEO INDEX have a paired relationship.
NOTE
When the next trigger is input before completion of the output of the video corresponding to
the trigger, there will be an effect on the video.
•
1 Pulse Trigger SYNC-NON RESET Picture Output Timing (at Time of Internal Sync)
1
Trigger*
3
VD OUT*
VIDEO INDEX
Video output
*1: Externally input signal
*2: Exposure time is determined by the setting of the MODE SELECT switch. Refer to page 10.
As long as there is no external sync input, the internal VD will be output when the rear
panel HD/VD signal input/output switch is set to the INT side.
*3: Video is output at the falling edge of the internal VD following completion of the exposure
period.
The video and the VIDEO INDEX have a paired relationship.
NOTE
When the next trigger is input before completion of the output of the video corresponding to
the trigger, there will be an effect on the video.
12
About 7 s
2
About 1H
525H (Partial scanning OFF)
175H (Partial scanning ON)
About 1 s
2
Exposure period*
525H (Partial scanning OFF)
175H (Partial scanning ON)
Negative polarity mode
Positive polarity mode
2
Exposure period*
The internal VD falling edge is within the exposure
period and thus video is not output.
Negative polarity mode
Positive polarity mode
2
Exposure period*
*
3
Advertisement
Table of Contents
