Linx 8900 Operating Manual page 173

Linx 8900 Operating Manual —
Look after your printer
6 When the Nozzle Clear sequence starts, apply the solvent to the nozzle face as
shown in Figure 166. Take care to build up a good coating of solvent on the nozzle
face (item "A"). The solvent enters the nozzle.
A
A progress bar shows you the progress of the Nozzle Clear sequence. If necessary,
you can touch the Stop button to cancel the Nozzle Clear operation.
Continue to apply solvent until the Nozzle Clear sequence is complete. If necessary,
7
you can perform more Nozzle Clear sequences when the sequence has finished
(repeat steps 1 to 8), or return to the Maintenance screen or Home screen.
8 To make sure that the nozzle is clear, start the jet. Make sure that the jet flows from
the nozzle into the gutter. If the jet is not aligned correctly, contact your local Linx
Distributor.
Figure 166. Apply the solvent to the nozzle
Page 166 of 182
40160
TP1A002–1 English
Aug 2015