Tripp Lite PDUH30-ISO Owner's Manual page 2

Important Safety Instructions
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during the installation,
operation and storage of this product. Failure to heed these instructions and warnings will void
the product warranty.
CAUTION: Only those who are properly trained or qualified to use this device should
do so. Anyone who is not trained or qualified should not use this device unless it is under the supervision of
someone who is properly trained or qualified to do so.
Children must be supervised to ensure they do not use the device as a toy.
Do not install this device if there is not at least 10 meters (30 feet) or more of wire between the electrical outlet
and the electrical service panel.
Never use the device if the cord and plug are damaged. If the device is not working properly,
or if it has been dropped or damaged, take it to an authorized service center for inspection and repair.
If the power cord is damaged, it must be replaced by the manufacturer, its authorized service agent or qualified
personnel in order to avoid a danger.
Important Warnings
• The PDU provides surge and line noise protection to connected equipment through its outlets.
• The PDU is designed for indoor use only, in a controlled environment, away from excess moisture, temperature
extremes, conductive contaminants, dust or direct sunlight.
• Keep indoor ambient temperature between 32°F and 77°F (0°C and 25°C).
• The PDU must be installed by a qualified technician only.
• Do not attempt to mount the PDU to an insecure or unstable surface.
• Install in accordance with National Electrical Code standards. Be sure to use the proper overcurrent protection for the
installation, in accordance with the plug/equipment rating.
• Connect the PDU to an outlet that is in accordance with your local building codes and that is adequately protected
against excess currents, short circuits and earth faults.
• The electrical outlets supplying power to the equipment should be installed near the equipment and easily accessible.
• Do not connect the PDU to an ungrounded outlet or to extension cords or adapters that eliminate the connection to
ground.
• The plug on the cord-connected models serves as the disconnect device.
• Be sure to provide a local disconnect device on any models that are permanently installed without a plug that is easily
accessible.
• Never attempt to install electrical equipment during a thunderstorm.
• Individual equipment connected to the PDU should not draw more current than the individual PDU's outlet's rating.
• The total load connected to the PDU must not exceed the maximum load rating for the PDU.
• Do not attempt to modify the PDU, input plugs or power cables.
• Do not drill into or attempt to open any part of the PDU housing. There are no user-serviceable parts inside.
• Do not attempt to use the PDU if any part of it becomes damaged.
• Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause
the failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended.
2