Roland J-6 Owner's Manual page 19

Item
AUTO, InT,
NIDI, USB
SYnC
(MIDI Clock Sync)
thrv OFF, On
(MIDI Thru)
txPc OFF, On
(TX Program Change)
rxPc OFF, On
(RX Program Change)
Pc.Ch (Program Change
1–16
Channel)
vELo 1–127
(Key Velocity)
433.0–448.0 Sets the master tuning.
tUnE
(Tune)
OFF, 1–127
USb.d
(USB Direct Out)
OFF, On
A.LnK
(AIRA Link) (*2)
Cnt.I OFF, 2–4
(Count In)
Copies the current pattern to a specified pattern.
The save destination number is shown in the display.
COPY
(Copy)
Initializes the currently selected pattern (including the sounds).
init
(Initialize Pattern)
*1: The settings are made for the currently selected pattern (and can be saved for each pattern).
*2: When using with another port besides the USB HOST 3 port on the MX-1, the unit starts up in battery-only mode. To use
battery-only mode, turn on the power while holding down the [C (EXIT)] button.
Value
Sets which synchronization signal is used by this unit.
AUTO (Auto): Inputted clocks are accepted.
InT (Int): The unit operates according to its internal clock.
NIDI (MIDI): Only MIDI input is accepted.
USB (USB): Only USB MIDI input is accepted.
* Note that when an external device is connected to the SYNC IN jack, the unit
always synchronizes to the clocks that are inputted to the SYNC IN jack.
Sets whether to output the messages that are input from the MIDI IN connector to the
MIDI OUT connector (ON) or not (OFF).
Sets whether program change messages are transmitted or not when the pattern
changes.
Sets whether the pattern changes when a program change message is received.
Sets the MIDI channel for transmitting/receiving the program change messages used
to change patterns.
Sets the keyboard velocity.
(Default value: 440.0 Hz)
Configures the volume of the signal output to USB.
OFF: Uses the VOLUME knob's setting.
1–127: Sets the volume apart from the VOLUME knob's setting.
Set this to ON when connecting a device via USB that is compatible with AIRA LINK,
such as the MX-1.
Otherwise, leave this at the OFF setting.
The setting takes effect after the unit is powered off and on again.
Sets the length (the number of beats) of the count-in for recording.
●
Use the [TEMPO/VALUE] knob to select the save destination number.
●
Press the [D (ENTER)] button to save.
●
If you want to cancel, press the [C (EXIT)] button.
Explanation
Functions and Menus
19