How To Make An Overdub On Track 2 - Tascam 414MKII PortaStudio Owner's Manual

Step-By-Step-Operation Guide
6
Routing tape signals to TAPE CUE
Locate the EFFECT 2/TAPE CUE level
control on channel 1 and slowly turn it to
the right. You'll hear, in center mono, what
you have recorded on track 1.
7
Stopping playback
'
Press STOP to stop playing.
18

How to Make an Overdub on Track 2

Overdubbing entails recording one or more
additional tracks on the same tape, while listening to
previously recorded tracks using TAPE CUE.
Leave the microphone connected to the channel 1
input. There is no need to repatch it to channel 2 to
record on track 2. You can send any mixer input to
any track of the recorder through the combination
use of PAN and RECORD FUNCTION.
1
Routing input
Set the channel 1 INPUT selection switch to
the MIC/LINE position.
2
Panning
Turn the channel 1 PAN control all the way
to the right (R) position.
3
Channel 1 level
Bring the channel 1 fader to the shaded area
(between 7 and 8).
4
Master level
Bring the MASTER fader to the shaded area
(between 7 and 8).
5
Monitor selection
L-R MONITOR
'
Press the MONITOR select switch L-R on.
(Leave the EFFECT 2/TAPE CUE switch
pressed on.)