Horizont StreetFlash Quick Manual

StreetFlash
Quick Guide
STREETFLASH IS OFF
Power on:
1 x tap
Power on:
π
1 x tap
Check battery status:
π
hold 3 sec
max. 5 yellow flashes = full
1 or 2 red flashes = low battery
De- / activate auto turn on function:
+ π hold 3 sec, 1 x π tap, wait 5 sec
This function is switched on by default and should
only be deactivated if necessary.
LED-CONTROL LIGHT
Glows green for approx. 5 sec: Powers on
Glows red for approx. 5 sec: Powers off
Flashes red: Pair mode on
1
1 Each additional lamp which is switched on becomes part of the group. The pair mode
turns itself off after 5 min or if you hold both buttons for 3 sec. Now you can start a
separate group.
There are two buttons to operate the StreetFlash:
On / off button
–
π
– Pi button
The table shows the buttons' functions, if pressed individually or simultaneously. There is either a "tap" or "hold
3 sec" option to operate the buttons.
It also matters whether the light is switched on or off
accordingly. Once a group is synced, each individual lamp can be used as a remote control for the whole group.
when pressing the buttons, as the functionality changes
STREETFLASH IS ON
Change light pattern:
1 x tap
1. (default) running light, 2. quick running light,
3. simultaneous flashing, 4. permanently on
Turn off all lights in group:
hold 3 sec
Change tilt sensor settings:
π
1 x tap
π
1. automatic, 2. top LEDs, 3. side LEDs
Turn off this light only:
π
hold 3 sec
Reverse sequence of running lights:
1 x +
π
Pairing mode on / off:
π
+
Allows the formation of separate groups if necessary.
Glows permanently red while plugged in: charging in progress
Glows permanently green while plugged in: charging process completed
Flashing while plugged in: battery error  unplug and plug in again
2 If the control light continues to flash, please contact our service team.
since 1945
π
tap
hold 3 sec
2