Table of Contents
Advertisement
From the initial factory settings, the MedVue WiFi (MVWIFI) option will appear as a wireless
access point with the name "MedVue". In order to connect to the weight analyzer, you can
connect to it as either an access point and then open a TCP/IP connection to the weight
analyzer, or you can set the WiFi option to connect to an existing network and then make a
TCP/IP connection to the weight analyzer.
In order to setup the MVWIFI to connect to an existing network, you will first need to connect
to it as an access point from a device able to make wireless connections, and can run a web
browser.
In order to put the MVWIFI into a state that will allow you to connect, regardless of the current
network settings:
1. Enter Setup Review of the MedVue weight analyzer by pressing and holding the BACK
key for 3 seconds.
2. Navigate to the TCP/IP settings and then the reset WiFi parameter.
3. Set the reset WiFi parameter to "Yes" and press ENTER.
Once this is complete, the MVWIFI should be broadcasting its SSID "MedVue".
1. At this point you can connect your wireless device (PC, laptop or mobile device) to the
MedVue SSID. Note that it may take up to one minute to connect.
2. Launch a web browser and navigate to:
http://192.168.1.1.
3. If your attempt to browse to this page is unsuccessful, you may need to disable any
other Ethernet adapters besides the wireless adapter being used to connect to the
MVWIFI module.
4. You should then be presented with a new page which contains a form that can be used
to set up the network configuration to either connect to an existing network, or act as a
wireless access point.
4
NETWORK CONFIGURATION
8555-M519-O1 Rev D • MedVue MVWIFI Operation
Advertisement
Table of Contents
