Table of Contents
Advertisement
Mounting the MVWIFI Option Card
NOTE: Should your weight analyzer come with the option card already installed, the following
section describing mounting, does not apply. Proceed to NETWORK CONFIGURATION.
ATTENTION! OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC
SENSITIVE DEVICES.
IMPORTANT! Make sure the power to the MedVue weight analyzer is off!
If you are operating the weight analyzer using batteries, remove them. If using the
optional power supply, unplug the power supply cable from the 12VDC jack on the
back of the weight analyzer.
1. With the power off, remove the two (2) screws from the right end cap (as viewed from the
front of the weight analyzer) and remove the end cap.
Option
Card
Connector
Figure No. 1
2. Locate the option card connector protruding out of the side panel. See Figure No. 1.
NOTE: The option card connector protruding out of the side panel is keyed or has a slot in
it (see Figure No. 1) and the connector on the option card connector is keyed or divided.
3. To install the MVWIFI option card, carefully align the connector on the MVWIFI option card
with option card connector protruding out of the side panel and apply even pressure to the
MVWIFI option card. See Figure No. 2.
4. Re-install the end cap and secure with the two (2) screws removed in step 1.
5. Press the ON/OFF key to turn the weight analyzer on.
6. The weight analyzer is now ready to configure for the network.
INSTALLATION
Note slot in
connector
8555-M519-O1 Rev D • MedVue MVWIFI Operation
MVWIFI
Option
Card
Figure No. 2
3
Advertisement
Table of Contents
