Table of Contents
Advertisement
4. Temporarily fit the inlet elbows to the
valve connections and the *mounting
bracket to base of the valve.
*Note: to fit the valve body to the
mounting bracket, push and twist
to engage the lugs.
5. Place valve body against the wall
with elbows over the pipe tails and
mark around the base where it sits
on the wall. To ensure the valve
will be straight upon fixing to the
wall, mark both the finished wall
and the mounting plate with a
central dot. These dots will be used
for ease of alignment when fixing
the bracket to the wall.
6. Remove the mounting bracket from
the valve body and place it in the
centre of the outlined valve position.
Align the dots made in step 5 and
mark the points for the fixing holes.
7. Drill holes for fixings suitable for the
wall type / construction. Use the
wall plugs and screws supplied if
suitable and secure the mounting
bracket to the wall.
6
Advertisement
Table of Contents
