Table of Contents
Advertisement
In the case that the pool is partially in-ground
the stepladder should be cut to adapt it to the
pool. For safety reasons, if the space between
the floor and the first step is between 80 and
230 mm (dimension A) close this space using
the step of the ladder you have removed so that
dimension B is less than 89 mm. To do that,
follow these steps:
1- Reduce the length of the step by 12 mm.
2- If dimension A is less than 140 mm, reduce
the width of the step so that when the step
is installed the space below its is completely
closed.
3- Assemble the modified step in the stepladder
as shown in the upper diagram, trying to pre-
cut the stepladder support.
For safety reasons, you should respect these
dimensions whatever the configuration of the
pool assembly.
B
A
IMPORTANT:
Admitted maximum weight = 150 kgs.
Its is COMPULSORY to remove the
stepladder after using the pool.
A
12
12
B
2
6x90
4
4x40
2 LADOS
88
235
12
A
Butterfly screw
Screw 5x70 mm
C
A
B
B
B
A
2 screws TRCC 120 mm
Fig. 26
EN
instalation
8
2
19
Advertisement
Table of Contents
