Advertisement
Access Preset
1. Press Preset to load and to switch presets.
2. If a preset is active and the preset footswitch is pressed for more than
1 second, the pedal will save any changes that have been made to the
current preset.
MIDI
Our pedals are prepared to be controlled by MIDI protocol on channel 1 to
channel 4 (check the operation guide to learn how to change the MIDI
channel), so you can access presets, save new presets and even control
individual parameters of your pedals via a MIDI controller. Below are
instructions on how to communicate with the pedal.
Our system does not use the standard MIDI interface, as there is no
optocoupler on the input, but this system is used in several pedals in this
industry. You will need a MIDI converter or controller with TRS P10 outputs
to use MIDI on our pedals. Below is the pinout to be followed:
VTR EFFECTS – HELIOS OVERDRIVE V2
Access Presets
Send a Program Change message with the preset number you want to access
(Example: Preset 1 = 10; Preset 2 = 20).
Save Presets
Hold the footswitch Bypass and send a Program Change message with the
preset number you want to save, the pedal will save the current setting in
the desired location (12 slots available).
Control Parameters
Send a Continuous Controller message according to the information below:
CC #1 - Effect ON/OFF (Value 127=ON / Value 0=OFF).
CC #2 - Clipping Modes:
• Value 1 = Silicon;
• Value 2 = Germanium;
• Value 3 = LED RED;
• Value 4 = Mosfet.
CC #3 - Gain (Submit a value from 0 to 127).
CC #4 - Level (Send a value from 0 to 127).
CC #5 - Tone (Send a value from 0 to 127).
CC #6 - Bass (Submit a value from 0 to 127).
Page 4
Advertisement
