3: Programming; Programming Data Entry Sections - DSC Communique VPM4580 Installation Manual

NOTE: For the VPM4580 to work, it must be enrolled
in the security control panel. Please see your security
system's Installation Manual for instructions.
With the system disarmed, perform the following to
access the VPM4580 Programming Mode:
1. To access your security system from a
Communiqué telephone, press the [
If you are using a Communiqué DAI station, press
[7][3]. The system will announce:
"Hello" "Hello" "Hello"
"Hello" "Hello"
2. Enter programming mode by pressing [*][8]. The
system prompts:
"Enter the Service Code" "Enter the Service Code" "Enter the Service Code" "Enter the Service Code" "Enter the Service Code"
3. Enter the 4-digit Service code. The default service
code is [4580]. You can change the service code in
programming section [001]. After the service code
is entered, the system prompts:
"Enter a Section Number. To exit, "Enter a Section Number. To exit, "Enter a Section Number. To exit, "Enter a Section Number. To exit, "Enter a Section Number. To exit,
press [#]" press [#]"
press [#]" press [#]" press [#]"
4. To enter a programming section, enter the 3-digit
number of the section. If you make an error
entering the section number, the system prompts:
"Invalid entry. Enter a Section "Invalid entry. Enter a Section "Invalid entry. Enter a Section "Invalid entry. Enter a Section "Invalid entry. Enter a Section
Number. To exit, press [#]" Number. To exit, press [#]" Number. To exit, press [#]" Number. To exit, press [#]" Number. To exit, press [#]"
When you enter a section number, the system
announces the section you have entered with the
prompt:
"Section (number)" "Section (number)" "Section (number)" "Section (number)" "Section (number)"
4
Programming
S e c t
] key.
SECURITY
firealarmresources.com
i o n

Programming Data Entry Sections

To program a data entry section from the VPM4580
programming mode:
1. Enter the 3-digit section number.
2. The system announces the section you have
entered with the prompt:
"Section (number)" "Section (number)" "Section (number)" "Section (number)" "Section (number)"
The system announces the data presently
programmed in the programming section as:
"Data is (data)" "Data is (data)"
"Data is (data)" "Data is (data)" "Data is (data)"
The system then prompts:
"Enter new data" "Enter new data"
"Enter new data" "Enter new data" "Enter new data"
3. Enter the new data in the section, or return to the
"Enter a Section Number" prompt, by pressing [#].
When you have finished entering the new data,
the system announces the new data with the
prompt:
"Data is (data)" "Data is (data)" "Data is (data)"
"Data is (data)" "Data is (data)"
If you make an invalid data entry, the system
announces:
"Invalid Entry. Data is (data). "Invalid Entry. Data is (data). "Invalid Entry. Data is (data). "Invalid Entry. Data is (data). "Invalid Entry. Data is (data).
Enter new data" Enter new data"
Enter new data" Enter new data" Enter new data"
4. Record the new data in the appropriate section of
the Programming Worksheets.
3