Table of Contents
Advertisement
Quick Links
INSTALLATION AND OPERATION MANUAL
FOR METERED BYPASS SOLUTIONS
This manual should be kept for future reference. If you have any questions regarding your water filter,
contact your local dealer, OEM, or the manufacturer at the following:
Lancaster Water Group | 1340 Manheim Pike, Lancaster, PA 17601 | lancasterwatergroup.com | 1-800-442-0786
EPA Est. 092577-OH-001
Advertisement
Table of Contents
Related Manuals for Lancaster Water Treatment ONE E3-M
Summary of Contents for Lancaster Water Treatment ONE E3-M
- Page 1 INSTALLATION AND OPERATION MANUAL FOR METERED BYPASS SOLUTIONS This manual should be kept for future reference. If you have any questions regarding your water filter, contact your local dealer, OEM, or the manufacturer at the following: Lancaster Water Group | 1340 Manheim Pike, Lancaster, PA 17601 | lancasterwatergroup.com | 1-800-442-0786 EPA Est.
-
Page 2: Where To Install
WHERE TO INSTALL CITY WATER INLET WATER METER GROUNDED & UNSWITCHED 115 - VOLT OUTLET GROUND STRAP PRESSURE TANK RELIEF VALVE MUST BE INSTALLED SERVICE PUMP WELL INLET NOTES • Select a proper location for installation. The unit must be installed • Plumbing the filtration system assembly: the inlet and outlet before the main water line connects to the water heater, near of the filtration housing are 1"... -
Page 3: Parts Diagram
PARTS DIAGRAM SHOWN IN DIAGRAM PART IDENTIFICATION PART NUMBER ONE-E3-M Filtration System / Housing CTA0840BBBKP5-06L00 In/Out Head for 1.050" Riser Pipe CT-IOHMBK-INOUT1050 90 Degree Vertical Elbow With/without Machined Drain Port CT-ELBOW-90DRAIN Flow Meter Assembly With Cord CT-METERASSY Meter Spacer Assembly CT-METERSPACER Bypass Manifold CT-IOHMBK-BYPASSMANIFOLD-GR... - Page 4 ASSEMBLY INSTRUCTIONS STEP 1: TANK ASSEMBLY (SEE DIAGRAM ON PREVIOUS PAGE) STEP 1A Wrap #9 (Drain Valve Assembly) with three clockwise wraps of Teflon tape. Install/thread ® #9 (Drain Valve Assembly) into #3. HAND TIGHTEN ONLY. STEP 1B Connect #3 to #2 on the bottom of Filter Housing #1. The threaded Drain Valve Assembly should be on the inlet side (right side) at the bottom of the tank.
-
Page 5: Installing The Cartridge
INSTALLING THE CARTRIDGE STEP 2: REMOVING THE TOP CAP STEP 2A Unseat the snap ring by pushing down on the top cap with both hands. Remove the ring by taking the handle and pulling inward, then upward; the ring should slide completely out. STEP 2B Remove the snap ring on the top of the tank, then remove the top cap from the housing assembly. -
Page 6: Replacing The Cartridge
REPLACING THE CARTRIDGE Turn off the water supply to the system by shutting off the inlet and outlet valves on the bypass. (Optional) Install a 3/8" PEX tubing hose to the provided fitting and shut-off that connects to the inlet side of the filtration system. - Page 7 LED REPLACEMENT NOTIFICATIONS EASY TO UNDERSTAND LED REPLACEMENT NOTIFICATIONS The Real-time Dynamic LED System monitors water and flow rate and provides a visual color-coded notification to the homeowner, letting them know when to replace their filter. GREEN: YELLOW: RED: FILTER CHANGE CHANGE GOOD...
-
Page 8: Contents Of Box
CONTENTS OF BOX Straight Connector 90 Degree Elbow Connectors (2) Umbrella Cap Filter Cap Flow Meter Assembly Bypass Manifold Filter Housing Vertical Elbows (2) In/Out Head w/ Filter Adapter 2.5" Inlet Cap Drain Valve Assembly Contents of the box you receive will vary depending on your order. If you have questions or concerns, please contact Lancaster Water Group at 1.800.442.0786. -
Page 9: Other Specifications
Flow Rate of Lead and PFOA/PFOS Odor Reduction Capacity Drop Spec ONE E3-M System and PIONEER Pb Filter >300,000 gallons @ 15 GPM (1,135,533 Liters @ 56.8 lpm) with greater than 90% Lead Reduction and PFOA/PFOS 8 GPM (30.2 lpm) reduction, estimated capacity using 2 100,000 gallons @ 4.51 GPM... -
Page 10: Operation
WATER TOTALIZER NOTIFIER The overall purpose of this device is to receive a water meter input and totalize the amount of water that passes through the meter. When there is flow through the water meter, the lights flash at a rate that increases with the water flow rate. When the total amount of water flowed reaches within 10% of a pre-selected amount the totalizer turns yellow. - Page 12 All information contained herein is the property of LANCASTER WATER TREATMENT. LANCASTER WATER TREATMENT makes no warranty of any kind with regard to this material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. LANCASTER WATER TREATMENT shall not be liable for technical or editorial errors or omissions contained herein or for incidental or consequential damages in connection with the furnishing, performance, or use of this material.