Maintenance - ubbink Poolspot 7504615 Manual

1
Operating instruction for swimming pool lighting LED 350 Plus Cold White / LED 406 Multicolor
Button 7 Green
Button 8 Green/Blue
Button 9 Blue
Button 10 Red/Blue
Button 11 Red/Green/Blue
Button 12 Lighting off

Maintenance

Attention! The power supply must always be interrupted before maintenance work on the swimming pool lighting (e.g. replacing the bulbs).
Replacing the bulbs
• Loosen at first the two fixing screws of the front ring and then remove the front ring together with the lighting housing out of the holding fixture (Figure 18).
If necessary, drain some water out of the pool; to the bottom edge of the front ring.
• Loosen the fastening screws of the front ring at the underside of the lighting body and then remove the lens cover with seal ring (Figures 19; 20)
• Loosen the fastening (4 screws) of the round LED-plate and remove it from the bottom plate (Figure 21).
Place the new LED-plate (Figure 22) onto the locating pins and fix the plate with the 4 screws.
IMPORTANT: Absolutely ensure that the LED-plate is placed correctly, i.e. congruent with the current lead marking (U+) on the locating pins.
ATTENTION! Handle the new LED-plate carefully when unpacking and inserting to avoid damage to the upper and especially underside of the plate.
• Now you can assemble and fasten your swimming pool lighting in reverse order (Figure 23).
Absolutely ensure correct fit of the seals and the lighting glass.
Overwintering:
For the winter time remove the safety transformer from the lighting cable and store it in a frost-free place. Protect the lighting cable plug against adverse weather conditions, like rain,
snow and frost. Disassembly of the fixed installed swimming pool lighting is not necessary.
Extension of the swimming pool lighting:
The connected lighting capacity must not exceed the rated capacity of the safety transformer!
Overloading can damage the safety transformer irreparable.
2
Garantie
We guarantee this product for two years against provable material and manufacturing faults, starting from the date of purchase. The original purchasing proof must be presented for
claims under this guarantee. The guarantee does not cover complaints caused by assembly and/or operating faults, insufficient care, frost damage, improper repair attempts, use of
force, third party faults, overload, mechanical damages or impact of foreign bodies. Also excluded from the guarantee are all complaints regarding damages to parts and/or problems,
which are due to wear.
Correct disposing of this product
This symbol points out inside the EU that this product must not be disposed via the household waste. Old devices contain valuable, recyclable materials, which should
be send to recycling and not cause damage to the environment or human health due to unchecked waste disposal. Please dispose therefore the old devices via suitable
collecting systems or send the device for disposal to the place you bought it from. This company will then pass on the device to material recycling.
Declaration of Conformity
The company UBBINK GARDEN BV declares in own responsibility that the swimminngpool lightings Poolspot LED 350 Plus cold white and Poolspot LED 406 multicolor meet the require-
ments of the EG-directives 2006/95/EG (Low voltage directive) and 2004/108/EG (Electromagnetic compatibility). The following harmonised standards have been applied:
EN 60598-1:2008+A11; EN 60598-2-18:1994+A1; EN 62493:2010; EN 62471:2008
EN 55015:2006+A1+A2; EN 61547:2009, EN 61000-3-2:2006+A1+A2; EN 61000-3-3:2008
20